VTech CTM-S2312 User Manual

8
SIP contemporary trimstyle 2-line - CTM-S2322
Telephone operation
Receive a call
When there is an incoming call, the telephone rings and the corresponding line key flashes.
To answer a call:
Press the flashing line key, or press
to pick up the ringing line. The respective line key illuminates when the phone line is in use.
The
key illuminates when in speakerphone mode.
Place a call
Press LINE 1, LINE 2 or . Listen for a dial tone and then dial the desired number. The respective line key illuminates when the
phone line is in use. The
key illuminates when in speakerphone mode.
End a call
Press OFF or place the handset back in its telephone base. The call ends when all handsets hang up.
Share a call
During a call on line 1 or line 2, another handset can join the call by pressing the respective line key or .
Speakerphone
During a call, press to switch between speakerphone mode and handset earpiece mode.
When the telephone is idle, press
. The first available line is selected, starting with line 1.
Redial
The last dialed number on the handset is stored for 15 minutes.
To redial the last dialed number:
Press LINE 1, LINE 2 or
to listen for a dial tone. Then press REDIAL.
Volume
Listening volume can be adjusted on the handset.
To adjust the listening volume:
During a call, press -/VOLUME/+ on it to adjust the listening volume. The next call returns to the default listening volume.
Call waiting
Call waiting supports 2-line phones configured as single SIP account only. To change the SIP account settings, refer to the
SIP Phone Configuration Guide for details.
When you hear a call waiting tone during a call, press the corresponding line key to put the current call on hold and take the new
incoming call.
Press the corresponding line key at any time to switch back and forth between calls.
Message waiting indicator
When a voice message is received, the MESSAGE WAITING LED on the handset flashes.
Mute
To mute the microphone:
During a call, press . The light turns on when the mute function is turned on. You can hear the party on the other end but
they cannot hear you.
Press
again to resume the conversation. The light turns off.
Hold
To place a call on hold:
During a call, press HOLD. The corresponding line key flashes when the call is on hold.
Press the flashing line key or
to release the call from hold, or the call will end automatically after the preset call on hold
duration. When both lines are on hold, press
only releases the call from hold on line 1.
1.
2.
1.
2.
1.
2.

VTech CTM-S2312 Specifications

General

Brand	VTech
Model	CTM-S2312
Category	Telephone
Language	English