EN - 15
Question Suggestion
I cannot dial out.
• Try all the above suggestions.
• A prefix may be required for dialing some
internal or external calls
• Make sure there is a dial tone before dialing.
It is normal if the cordless handset takes
a second or two to synchronize with the
telephone base before producing a dial
tone. Wait an extra second before dialing.
• Check your server settings. If other
telephones in your hotel are having the
same problem, the problem is in the wiring
or network server. Contact your telephone
service provider (charges may apply).
The telephone cannot register to the network
server.
• Make sure your network is providing Power
over Ethernet (PoE).
• Make sure the initialization and system
registration process completes.
• If there is an error during the initialization
and system registration process, the /
SPEAKER key flashes twice every second.
Disconnect the Cat-5 network cable from
the network wall jack and connect it back
into the network wall jack with Power over
Ethernet (PoE) to start the initialization and
system registration process again.
The telephone does not ring when there is an
incoming call.
• Make sure the Cat-5 network cable is
plugged into the LAN port of the telephone
base and the network wall jack with Power
over Ethernet (PoE).
• Check your server or telephone
administrative settings.
• If other telephone in your hotel are having
the same problem, the problem is in the
wiring or network server. Contact your
telephone service provider (charges may
apply).
• Other electronic products such as HAM
radios and other DECT phones can cause
interference with your cordless phone. Try
installing your phone as far away as possible
from these types of electronic devices.
• The Cat-5 network cable may be defective.
Install a new Cat-5 network cable.
To Next Page
Loading...
Need help?
General
