EN - 14
Appendix
Troubleshooting
If you have difficulty with the telephones, please try the suggestions below. For customer service, visit our
website at www.vtechhotelphones.com or call 1-888-907-2007.
For corded telephone
Question Suggestion
The telephone does not work at all.
• Make sure a Cat-5 network cable is plugged
into the LAN port of the telephone base
and the network wall jack with Power over
Ethernet (PoE).
• Unplug the Cat-5 network cable from the
network wall jack. Wait for approximately 15
seconds, then plug it back in.
• Disconnect the telephone base from the
network wall jack and connect a different
working telephone. If the other telephone
does not work, the problem is probably in
the wiring or network server.
There is no dial tone.
• Try all the above suggestions.
• The Cat-5 network cable may be defective.
Install a new Cat-5 network cable.
• Make sure your network is providing Power
over Ethernet (PoE).
• Disconnect the telephone base from the
network wall jack and connect a different
working telephone. If there is no dial tone
on this telephone either, the problem is in
your wiring or network server.
• Make sure the initialization and system
registration process completes. The
speakerphone key blinks twice every second
if there are errors with the initialization and
system registration process.
I hear other calls when using the telephone.
• Disconnect the telephone base from the
network wall jack andconnectaand connect
a different working telephone. Check your
server settings. If calls are still not clear, the
problem is probably in the wiring or network
server. Contact your telephone service
provider (charges may apply).
The Speed Dial key does not work at all.
• The Speed Dial key may not be properly
programmed.
To Next Page
Loading...
Need help?
General
