12
Basic answering system setup via voice guide
You can follow the voice guide to record your own announcement, set the number
of rings and set the message alert tone.
Using the telephone base:
1. Press MENU twice.
2. / -> Voice guide -> SELECT.
3. Set up the answering system by inputting the designated numbers, as
instructed.
Add a Bluetooth
®
cell phone/headset
Note: Your DLP73210/DLP73410/DLP73440/DLP73510/DLP73540 is compatible with Bluetooth
version 2.0 or above devices.
To use a Bluetooth enabled cellular phone or headset with your telephone, you
must rst pair and connect your Bluetooth cellular phone or headset with the
telephone base.
Bluetooth wireless technology operates within a short range (up to 30 feet). Keep
the connected device within 15 feet of the telephone base for optimal performance.
To pair and connect a cell phone using the telephone base:
1. MENU -> / -> Bluetooth -> SELECT.
2. SELECT to select Add cellular.
3. Press SELECT again to turn on the telephone base discoverable mode.
4. Place the cell phone next to the telephone base. Turn on the Bluetooth feature
of your cell phone and search for or add new advices. Once your cell phone nds
your AT&T phone (AT&T DECT 6.0), press the appropriate key on your cell phone
to continue the pairing process.
To pair and connect a headset using the telephone base:
1. MENU -> / -> Bluetooth -> SELECT.
2. / -> Add headset -> SELECT.
3. Set your headset to discoverable mode -> Press SELECT.
Record your own announcement
Your outgoing announcement plays when calls are answered by the answering
system. You can use the preset announcement to answer calls, or replace it with
your own recorded announcement.
Initial basic settings
To Next Page
Loading...
Need help?
General
