16
16
16
10. Insert the Panel Supports
into the Workbench Top and
use two of the Gray Toy
Screws and the included Drill
or Screwdriver to tighten the
supports.
11. Clip the two Trays into the
slots to the left and right of
the Workbench Top.
12. Use a Gray Toy Screw and the
included Drill or Screwdriver to
attach the Clock to the Panel of
the Workbench.
13. Screw a Peg to the Panel of the
Workbench and hang the Wrench
or Hammer on the Peg, or insert
the Wrench or Hammer into a slot
on the Panel of the Workbench.
To Next Page
Loading...
