38
Set remote access code
A two-digit security code is required to
access the answering system remotely
from any touch-tone telephone. The
preset code is 19. You can set the code
from 00 to 99.
Press MENU when the phone is not
in use.
Press or to scroll to Answering
sys then press SELECT.
Press or to scroll to Ans sys
setup then press SELECT.
Press or to scroll to Remote
code, and then press SELECT.
Use the dialing keys to enter a two-
digit number.
-OR-
Press or to scroll to a desired
two-digit number.
Press SELECT to save and you hear
a confirmation tone.
Call screening
To screen a call at the telephone
base:
If the answering system and call
screening are turned on, the
announcement and the incoming
message broadcast at the telephone
base while the call is answered by the
answering system.
Options while a message is being
recorded:
Press -/VOL/+ to adjust the call
screening volume.
Press -/VOL/+ to temporarily turn on
the call screening if the call screening
is set to off.
Press /PLAY/STOP to temporarily
turn on or off the call screening.
1.
2.
3.
4.
5.
6.
•
•
•
To screen a call at a handset:
If the answering system is on, a call is
answered by the answering system. At
the same time, the handset shows To
screen call press [SELECT]. Press
SELECT to screen the call on your
handset. The handset shows the caller’s
information. If you do not subscribe to
caller ID service, the handset shows
Screening...
Options while a message is being
recorded:
Press VOLUME/ or VOLUME/ to
adjust the call screening volume.
Press to switch between
speakerphone mode and handset
mode.
Call intercept
If you want to talk to the caller whose
message is being recorded, press
/HOME or
on the handset.
•
•
To Next Page
Loading...
Need help?
General
Weight and Dimensions
