VTech DS6621 Abridged User Manual

13
3FUSJFWFWPJDFNBJMGSPNUFMFQIPOFTFSWJDF
3FUSJFWFWPJDFNBJM
When you received a voicemail, the handset displays and /FXWPJDFNBJM. To
retrieve, you typically dial an access number provided by your telephone service
provider, and then enter a security code. Contact your telephone service provider
for instructions on how to configure the voicemail settings and listen to messages.
&YQBOEZPVSUFMFQIPOFTZTUFN
"EEBOESFHJTUFSBIBOETFU
You can add new cordless handsets (%4), DECT 6.0 cordless headset,
speakerphone, or speaker box to your telephone system (purchased separately).
Your telephone system supports a maximum of five devices.
Additional devices registered to the telephone system are assigned numbers in the
sequential order. Register each device with the telephone base before use.
When first purchased and properly charged, each expansion handset shows
5PSFHJTUFS)4and TFFNBOVBM alternately. Charge the handset before
registering it to the telephone base.
To register a DECT 6.0 cordless headset, speakerphone, or speaker box to this
telephone system, please refer to the user’s manual of the respective product for
more details. To register a cordless handset, see below.
5PSFHJTUFSBIBOETFU
Place the new/non-registered handset in the telephone base. The handset
shows 3FHJTUFSJOH
The handset shows 3FHJTUFSFE and you hear a beep when the registration process
completes. The registration process takes about 90 seconds to complete.
%FSFHJTUFSBMMEFWJDFT
To replace a handset or reassign the designated handset number of a registered
handset, you must deregister all devices and then individually register each handset.
5PEFSFHJTUFSBMMEFWJDFT
Press and hold
'*/%)"/%4&5 on the telephone base for about 10 seconds
until the */64& light on the telephone base flashes.
Immediately press
'*/%)"/%4&5 again.
All handsets show5PSFHJTUFS)4and TFFNBOVBM alternately when the
deregistration process completes. The deregistration process takes about
10 seconds to complete.
'SFRVFOUMZBTLFERVFTUJPOT
If you have difficulty with your telephone, please try the suggestions below.
If you cannot find the answer to your question, contact customer service by visiting our
website at XXXWUFDIQIPOFTDPN or calling . In Canada, go to XXX
WUFDIDBOBEBDPN or call .
*DBOOPUBEEBOEDPOOFDUNZDFMMQIPOFPSIFBETFUUPUIFUFMFQIPOFCBTF
Make sure you have cellular coverage and the Bluetooth function of your cell phone or headset
is turned on. See the user’s manual of your cell phone or headset for more information.
Make sure that the telephone base is in discoverable mode.
Carefully follow the pairing instructions on page 6-7. Make sure that your Bluetooth cell
phone or headset is not connected to any other Bluetooth device, and is connected to the
telephone base and active on the device list.
Remove 75FDI%4 from your cell phone’s handsfree device history list (see the user’s
manual of your cell phone for more information).
Turn off your cell phone or headset, and then turn it on again.
For some cell phones, you must authorize 75FDI%4 device in your cell phone’s Bluetooth
feature. See the user’s manual of your cell phone for more information.
Most cell phones have the Bluetooth feature in the connection or setup menus. Please refer
to the user’s manual of your cell phone.In general, press the menu key on your cell phone,
and then look for the Bluetooth menu in the settings or connection menu. In the Bluetooth
menu, select the option to search for or add new devices.
Reset the telephone base. Unplug the unit’s electrical power. Wait for approximately 15
seconds, and then plug it back in. Repeat the above suggestions
5IF1*/POUIFUFMFQIPOFCBTFEPFTOPUXPSL
Make sure you enter the correct PIN. The default PIN is .
$BOUIF%4IFMQUIFQPPSDFMMQIPOFSFDFQUJPOJONZIPVTF
If your cell phone has poor reception in your home, the %4 cannot improve the
reception. However, if there is a location in your house with better reception, you can leave
your cell phone at that location while you use the %4 cell line. In order for this to work,
the telephone base must be within 30 feet of the cell phone.
•
1.
2.
•
•
•
•
•
•
•
•
•
•
Do not place the
handset in the charger.

VTech DS6621 Specifications

Frequencies and Channels

DECT frequency	1921.536-1928.448 MHz
Bluetooth frequency	2402.000-2480.000 MHz
DECT channels	5
Bluetooth channels	79

Power Requirements

handset battery voltage	2.4 V
charger voltage	6 V
charger current	300 mA

Memory

phonebook memory locations	1000
phonebook digits capacity	30 digits
phonebook characters capacity	15 characters
caller ID log memory locations	50
caller ID log digits capacity	24 digits
caller ID log characters capacity	15 characters