Appendix
75
Expand your telephone system
The handset(s) and headset provided with your telephone system are already
registered. Each handset is assigned a number that displays on the handset.
Additional handsets registered to the telephone system are assigned numbers
in the sequential order. This telephone system accommodates up to 12 devices,
including a maximum of two DECT 6.0 headsets. The telephone base recognizes
and counts a headset the same as a handset.
Add and register a handset
You can add new handsets (DS6071, purchased separately) to your telephone
system. Each handset must be registered with the telephone base before use.
When first purchased and properly charged, each expansion handset shows
To register HS, see manual. You may need to charge the handset before
registering it to the telephone base. For more details on battery charging, see the
table on page 4.
To register a handset:
Place the new/non-registered handset you wish to register
in the telephone base.
The handset displays Registering...Please wait and the
red IN USE light on the telephone base turns on. It takes
about 90 seconds to complete the registration process. The
handset displays HANDSET X Registered. The IN USE
light turns off and the handset beeps when registration
completes.
If registration fails, the handset displays Registration failed then
To register HS, see manual.
To reset the handset, remove it from the telephone base. When the handset
displays To register HS, see manual., try the registration process again.
After registration, the date and time needs to be reset. For instructions,
see Set date and time on page 31.
1.
2.
Appendix
To Next Page
Loading...
Need help?
General
Weight and Dimensions
