Appendix
76
Add and register a headset
The telephone system accommodates up to two cordless headsets. You can add
a new headset (IS6100, purchased separately) to your telephone system. The
headset must be registered with the telephone base before use. You may need to
charge the headset before registering it to the telephone base. For more details on
headset charging, see page 5.
To register a headset:
Place the non-registered headset in the
telephone base and allow it to charge for at
least 15 minutes before beginning registration.
Remove the headset from the telephone base.
The light on the headset flashes slowly and
alternately in red and blue.
On the telephone base, press and hold
FIND HANDSET for about four seconds until
the red IN USE light turns on.
Immediately place the headset in the telephone base. It takes about 60 seconds
to complete the registration. The red IN USE light on the telephone base turns off.
The light on the headset turns red when it is registered but not fully charged, or
turns blue if it is registered and fully charged.
If registration is successful, you hear a dial tone when you press on the headset. If
registration fails, you hear “Not registered” through the headset earpiece when you
press on the headset. The light on the headset flashes slowly and alternately
in red and blue. To reset the headset, remove it from the telephone base and then
place it back into its charger. Try the registration process again.
The headset must be deregistered before registering it to another telephone system.
1.
2.
3.
The light
To Next Page
Loading...
Need help?
General
Weight and Dimensions
