VTech ErisStation VCS712 User Manual

17
California Energy Commission (CEC) battery charging
testing instructions
This telephone is set up to comply with the energy-conserving standards right
out of the box. These instructions are intended for CEC compliance testing
only. When the CEC battery charging testing mode is activated, all telephone
functions, except battery charging, will be disabled. These instructions assume
that all devices have been registered to the base station before activating this
test mode.
To activate CEC battery charging testing mode:
1. Remove the conference phone from the charging dock.
2. Remove the battery from the conference phone.
3. Press and hold MUTE on the conference phone.
4. With the MUTE key pressed, insert the battery in the conference phone, and
then wait for 5 seconds.
5. When the conference phone status indicators start ashing red, release
MUTE, and then press MUTE immediately. The conference phone displays
the mess-age: “To use the phone again, please reset the power.”
6. Put the conference phone on the charging dock to charge the conference
phone battery. The battery icon indicates the charge status as the
battery charges.
To deactivate CEC battery charging testing mode:
1. Remove the conference phone from the charging dock.
2. Remove the battery from the conference phone.
3. Reinsert the battery in the conference phone without pressing any keys.

VTech ErisStation VCS712 Specifications

General

Brand	VTech
Model	ErisStation VCS712
Category	Conference Phone
Language	English