How to reset VTech IP Phone to factory settings?
To reset your VTech IP Phone to its factory settings, you must be in administrator mode. Once in administrator mode, go to Maintenance, then select Reset values, and enter the administrator password.
How to reboot VTech ErisTerminal ET635?
To reboot your VTech IP Phone, press the Maintenance button, then select Reboot, and confirm the action.
General| Type | IP Phone |
|---|---|
| Lines | 12 |
| Speakerphone | Yes |
| Bluetooth | No |
| WiFi | No |
| SIP Compliance | Yes |
| VPN Support | No |
| Wall Mountable | Yes |
| Connectivity | Ethernet |
| Power | Power over Ethernet (PoE) or AC adapter |
| Protocols Supported | SIP |
| Headset Jack | Yes |
| Supported Codecs | G.711, G.722, G.726, G.729a |
| HD Voice | Yes |
| Security | TLS |
| Weight | 1.1 kg |
Essential precautions for safe operation and installation of the telephone equipment.
Steps for initial setup, network connection, and account registration.
Instructions for initiating calls using various methods like handset or headset.
How to answer incoming calls through different audio devices.
How to transfer calls after announcing them to the recipient.
How to transfer calls without prior announcement.
Managing phone accounts or 'phone numbers' for different providers.
Steps to manually download and install firmware updates.
Instructions for restarting the phone to resolve operational issues.
Guide to restore the phone to its original factory settings.
To Next Page
