7
7
7
How to Install the Ink Pad
With the Glitter Me Kitty, adult assembly is required.
Please note that Glitter Me Kitty comes with a pink decorative cover
on her paw. This cover will need to be removed and the ink pad
installed so that the Glitter Me Kitty can stamp hands.
1. Pull the decorative cover off the kitten’s paw.
2. Remove the ink pad from the aluminum
packaging and remove the plastic ink cover
from the ink pad.
3. Put the ink pad on the kitten’s paw, with the
tip of the heart pointed toward the paw.
4. Press down firmly on both sides of the ink
pad. You will hear it click into place when
inserted properly. The ink pad is now ready
to use.
5. Put the decorative cover and plastic ink
cover together by aligning their latches,
and store them on the bottom of the kitten,
with the cover’s latch facing the Off/Low/
High Volume Switch and decorative cover
facing in.
6. When not using the ink pad for an extended
period, we suggest taking it out, putting the
ink cover back on and storing it in a cool,
dry location.
7. Clean the stamp and the inside of the
kitten’s paw with a damp cloth, then place
the decorative cover back on the top of the
kitten’s paw for protection.
8. The ink washes off with soap and water.
To Next Page
Loading...
