VTech Go! Go! Smart Animals Zoo Explorers Playset - Zoo Entrance Battery Installation

10
BATTERY INSTALLATION - Zoo Entrance
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom
of the zoo entrance. Use a coin or a
screwdriver to loosen the screw.
3. Install 2 new ‘AAA’ (AM-4/LR03)
batteries following the diagram inside
thebatterybox.(Theuseofnewalkaline
batteries is recommended for maximum
performance.)
4. Replace the battery cover and tighten the screw to secure the battery
cover.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc)orrechargeable(Ni-Cd,Ni-MH),ornewandusedbatteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinre.
• Donotchargenon-rechargeablebatteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to becharged under adult
supervision.
Getting Started