VTech Go! Go! Smart Animals Zoo Explorers Playset - Water Tank Assembly; Getting Started; Rhino Battery Installation

9
Water Tank
1. Attach the SmartPoint™ water tank exit ramp and the ramp to the
water tank.
2. Attach the water tank gate to the water tank.
3. Attach the fully assembled water tank to the rocky path spiral ramp
as shown.
After the above steps, connect these pieces to the included track pieces.
Youcancongurethemintodifferentarrangements.
GETTING STARTED
BATTERY INSTALLATION - Rhino
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of
the rhino. Use a coin or a screwdriver to
loosen the screw.
3. Install2new‘AAA’(AM-4/LR03)batteriesfollowingthediagram
inside the battery box. (The use of new alkaline batteries is
recommendedformaximumperformance.)
4. Replace the battery cover and tighten the screw to secure the battery
cover.
Assembly Instructions / Getting Started