26
26
TROUBLESHOOTING
Consult this section if you experience difculty while operating your
KidiZoom
®
PrintCam camera.
Problem Solution
The camera is
not working
1. Turn the Master Power Switch off for 30
seconds.
2. Turn the Master Power Switch on again and
then press the Home/On/Off Button to turn it
on. The camera should now work properly.
3. If the camera still does not work, recharge the
battery and try again.
Screen
display is
abnormal
1. Turn the Master Power Switch off for 30
seconds.
2. Turn the Master Power Switch on again and
then press the Home/On/Off Button to turn it
on. The screen display should be normal again.
Photos and
videos are not
clear
1. Make sure the lighting conditions of the shooting
environment are adequate.
2. Check to see if the Lens is clean.
Recorded
video is not
smooth
• Check your memory card’s performance. We
recommend using a Class 10 or above microSD
or microSDHC card. Using a memory card with
lower performance may slow the video data-
writing on the card and thus affect the video
quality.
• The performance of some memory cards will
slow down after they have been used for a long
time. If you have this problem, rst back up your
les and then re-format the card.
Can not
connect to
computer
• Check the connections on the USB cable
between the camera and the computer and
review the connection procedures in this
manual.
• Turn the Master Power Switch off for 30
seconds. Turn the Master Power Switch on and
connect to the computer again.
To Next Page
Loading...
