VTech Launch & Chase Police Tower - Getting Started; Battery Installation; Battery Notice

7
7
7
GETTING STARTED
BATTERY INSTALLATION
Police Car
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
bottom of the Police Car. Use a coin
or screwdriver to loosen the screw.
3. Install two new AAA (AM-4/LR03)
batteries following the diagram inside
the battery box. (The use of new
alkaline batteries is recommended
for maximum performance.)
4. Replace the battery cover and tighten
the screw to secure the battery cover.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc)orrechargeable,ornewandusedbatteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Remove rechargeable batteries from the toybeforecharging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.