4
GETTING STARTED
The batteries included are for demo purposes only. Please replace
the low capacity Try Me batteries with new batteries for the best
performance. Slide the Off/Shoulder Mode/Cuddle Mode Switch to
the Shoulder Mode or Cuddle Mode position to start.
Battery Removal and Installation
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of the unit. Use a
screwdriver to loosen the screw and then open the battery cover.
3. If used batteries are present, remove these batteries from the
unit by pulling up on one end of each battery.
4. Install 2 new AAA (AM-4/LR03) batteries following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended).
5. Replace the battery cover and tighten the screw to secure.
To Next Page
Loading...
Need help?
General