VTech My 1st ToolBox - Getting Started with Your ToolBox; Battery Installation Guide; Battery Usage and Safety Notices

4
GEttInG StArtEd
BATTERY INSTALLATION
NOTE: For best performance, remove all factory-installed batteries
from the VTech
®
My 1st ToolBox and use new alkaline
batteries.
1. Make sure the unit is OFF.
2. Locate the battery cover on the bottom of
the ELECTRONIC TRAY and open it with a
screwdriver.
3. Install 2 new AA size batteries following
the diagram inside the battery box. (New
alkaline batteries are recommended for
maximum performance.)
4. Replace the battery cover and tighten the
screw to secure.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
GEttInG StArtEd