4
INSTRUCTIONS
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of the unit.
Use a coin or screwdriver to loosen the screw.
3. If used batteries are present, remove these
batteries from the unit by pulling up on one
end of each battery.
4. Install 2 new ‘
AA
’ (AM-3/LR6) batteries
following the diagram inside the battery box.
(For best performance, alkaline batteries or
fully charged Ni-MH rechargeable batteries
are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING
Adult assembly required for battery installation.
Keep batteries out of reach of children.
To Next Page
Loading...
Need help?
General