EasyManua.ls Logo

VTech RM2751 - Cautions; Pacemaker Precautions; Electromagnetic Fields (EMF)

VTech RM2751
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
9
Test the sound level and position the
baby monitor
Charge the parent unit battery before use
The parent unit runs on an internal rechargeable battery or AC power. To continuously
monitor your baby, keep the parent unit connected to AC power. With the battery alone, the
parent unit can cordlessly run for a short time only.
Notes
Before using the baby monitor for the first time, charge the parent unit battery for 12 hours. When
the parent unit battery is fully charged, the battery icon segments are solid
.
The standby time varies depending on your actual use.
The battery icon indicates the battery status (see the following table).
Battery indicators Battery status Action
and are displayed on
the parent unit screen;
the LED light flashes.
The battery has very little
charge and may be used
for only a short time.
Charge
without interruption
(about 30 minutes).
The battery icon segments are
solid
.
The battery is fully
charged.
To keep the battery charged,
connect it to AC power when
in use.
Raise the parent unit antenna for better reception
The parent unit turns on automatically
after it connects to the power socket,
and the welcome screen appears. You
can press to turn it on or
press and hold to turn it off.
Note
This video monitor is intended as an aid. It is not a substitute for proper adult supervision, and should not
be used as such.
Testing the sound level of the video monitor
For hearing protection, make sure the parent unit is more than 1 metre away from the baby
unit. If you hear any feedback noise from the parent unit, move the parent unit further until the
noise stops. You can also press on the parent unit to lower or mute the noise.
Increase the parent unit speaker volume if you cannot hear the sounds transmitted from the baby unit.
Positioning the video monitor
Keep the baby unit out of the reach of your baby. Never
place or mount the baby unit inside the baby’s cot or
playpen.
1. Place the baby unit more than 1 metre away from
your baby.
2. Adjust the angle of the baby unit to aim at your baby.
>1m

Other manuals for VTech RM2751

Related product manuals