18
19
mount the baby unit (optional)
1. Place the wall mount
bracket on a wall and
then use a pencil to mark
two holes in parallel.
Remove the wall mount
bracket and drill two
holes in the wall
(5.5mm drill bit).
Notes
• Check for reception strength
and camera angle of the baby
unit before drilling the holes.
• The types of screws and wall
plugs you need depend on
the composition of the wall.
You may need to purchase
the screws and wall plugs
separately to mount your
baby units.
2. If you drill the holes into a stud, go
to step 3.
• If you drill the holes into an
object other than a stud, insert
the wall plugs into the holes.
Tap gently on the ends with a
hammer until the wall plugs are
flush with the wall.
3. Align the wall mount bracket and screws
with the holes in the wall as shown. Tighten
the screw in the middle hole first, so that the
wall mount bracket position is fixed. You can
tighten the other screw in the top hole.
4. Place the baby unit on the wall
mount bracket, and then slide it
forward until it locks into place.
Connect the power adapter to the
baby unit and a power supply.
OR
3. Insert the screws into the holes
and tighten the screws until only
6mm of the screws are exposed.
4. Place the baby unit on the
wall mount bracket, and then
slide it forward until it locks
into place. Align the holes on
the wall mount bracket with
the screws on the wall, and
slide the wall mount bracket
down until it locks into place.
1
2
To Next Page
Loading...
