VTech RM9761 - Page 10

10
Mount the Camera (optional)
1. Place the wall
mount bracket on
a wall and then
use a pencil to
mark two holes in
parallel. Remove
the wall mount
bracket and drill
two holes in the
wall (5.5 mm drill
bit).
2. If you drill the holes
into a stud, go to
step 3.
• If you drill the holes
into an object other
than a stud, insert
the wall plugs into
the holes. Tap gen-
tly on the ends with
a hammer until the
wall plugs are flush
with the wall.
3. Align the wall
mount bracket and
screws with the
holes in the wall as
shown. Tighten the
screw in the middle
hole first, so that the
wall mount bracket
position is fixed.
You can tighten the
other screw in the
top hole.
3. Insert the screws
into the holes and
tighten the screws
until only 6.5 mm
of the screws are
exposed.
4. Place the camera on the wall mount
bracket, and then slide it forward until it
locks into place. Align the holes on the
wall mount bracket with the screws on
the wall, and slide the wall mount bracket
down until it locks into place.
5. You can maximise your camera viewing angle by
tilting the wall mount bracket.
Hold the camera, and then rotate the knob in an
anticlockwise direction. This will loosen the joint
of the wall mount bracket.
Tilt your camera up or down to adjust to your
preferred angle. Then, rotate the knob in a
clockwise direction to tighten the joint and
secure the angle.
OR
4. Place the camera on the wall mount bracket,
and then slide it forward until it locks into
place. Connect the power adaptor to the
camera and a power supply.
2
1