VTech Safari Sounds - Package Contents and Setup; Battery Installation

3
3
3
INCLUDED IN THIS PACKAGE
• One VTech
®
Safari Sounds Guitar
• One Parent’s Guide
WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy and should be discarded for your child’s safety.
NOTE: Please keep this parent’s guide as it contains important
information.
Removing the packaging locks:
Rotate the packaging locks anticlockwise 90
degrees.
Pull out the packaging locks and discard.
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned OFF.
2. Locate the battery cover at the back of
the unit. Use a screwdriver to loosen the
screw and remove the cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AA (LR6/AM-3) batteries
into the main unit following the diagram
inside the battery box. (The use of new,
alkaline batteries is recommended for
maximum performance).
5. Replace the battery cover and tighten the screw to secure.
THIS DEVICE COMPLIES WITH PART 15 OF THE
FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS: (1) THIS
DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.
CAN ICES-3 (B)/NMB-3(B)
MADE IN CHINA
FABRIQUÉ EN CHINE
TM & © 2020 VTech.