VTech Stack & Balance Teeter Totter - Getting Started; Battery Installation; Battery Notice

GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned Off.
2. Locate the battery cover on the back
of the unit. Use a screwdriver to
loosen the screw.
3. Install 2 new AAA (AM-4/LR03)
battery following the diagram inside
the battery box. (The use of a new
alkaline battery is recommended for
maximum performance.)
4. Replace the battery cover and tighten
the screw to secure.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc)orrechargeable,ornewandusedbatteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Removerechargeablebatteriesfromthetoybeforecharging
(ifremovable).
• Rechargeable batteries are only to be chargedunderadult
supervision.
4