VTech Switch & Go Dash the T-Rex User Manual

5
GETTING STARTED
BATTERY INSTALLATION
1. Make sure that Dash and the remote
control are turned OFF.
2. Locate the battery covers on the top of
Dash (see next page for details) and
on the back of the remote control. Use a
screwdriver to loosen the screws.
3. First, install 6 new AA (LR6/AM-3)
batteries following the diagram inside
the battery box of Dash. Then, install 2
new AA (LR6/AM-3) batteries following
the diagram inside the battery box of the
remote control. (The use of new alkaline
batteries is recommended for maximum
performance).
4. Put the battery covers back on Dash and the remote control. For
Dash,youwillneedtopressdownrmlyonthecovertocloseit,
then tighten the screw.
NOTE: When the batteries run low on power, Dash may no longer
respond. If this happens, please replace the batteries with brand
new ones.

VTech Switch & Go Dash the T-Rex Specifications

General

Brand	VTech
Model	Switch & Go Dash the T-Rex
Category	Toy
Language	English