VTech SWITCH & GO DINOS Overseer the T-Rex User Manual

5
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
Overseer the T-Rex
1. Make sure the unit is turned OFF.
2. Locate the battery covers on
the back of each foot and use a
screwdriver to remove them.
3. Remove old batteries by pulling
up on one end of each battery.
4. Install 6 new AA (LR6/AM-3)
batteries following the diagram
inside the battery box. (The
use of new alkaline batteries
is recommended for maximum
performance).
5. Replace the battery covers.
Remote Control
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of the
controller and use a screwdriver to remove it.
3. Remove old batteries by pulling up on one
end of each battery.
4. Install 2 new AAA batteries following the
diagram inside the battery box. (The use of
new alkaline batteries is recommended for
maximum performance).
5. Replace the battery cover.
WARNING:
Adult assembly required.
Batteries are to be installed by adult.
Keep batteries out of reach from children.
521063 IM.indd 5521063 IM.indd 5 03/19/2021 11:54:3903/19/2021 11:54:39

VTech SWITCH & GO DINOS Overseer the T-Rex Specifications

General

Brand	VTech
Model	SWITCH & GO DINOS Overseer the T-Rex
Category	Toy
Language	English