VTech Toot-Toot Drivers Construction Site - Assembly Instructions; Spiral Track Assembly

12
ASSEMBLY INSTRUCTIONS
1. Assemble and attach the 3-loop spiral track components following
the steps as below:
A: Insert one Spiral Support into the Spiral Track Base, attach
the other Spiral Support. Make sure you hear a clicking sound to
confirm they are firmly connected. Tighten it with two screws to
secure.
B: Insert Track A into the Spiral Support, attach Track B to Track
A, attach Track C to Track B. Attach the Sign into the Tower
Top, insert the SmartPoint™ launcher to Track A. Insert the
Guideboard Shaft to Track B first, then attach the Guideboard
into the Guideboard Shaft.
With the VTech
®
Toot-Toot Drivers
®
Construction Site, safety
comes first. To ensure your child’s safety, adult assembly is required.