4
GETTING STARTED / BATTERY INSTALLATION
GETTING STARTED
BATTERY INSTALLATION – VEHICLE
1. Make sure the unit is turned OFF.
2. Locate the battery cover on
the back of the race car. Use a
screwdriver to loosen the screw.
3. Install 3 new AAA (AM-4/LR03)
batteries following the diagram
inside the battery box. (The
use of new alkaline batteries
is recommended for maximum
performance.)
4. Replace the battery cover and tighten the screw to secure.
BATTERY INSTALLATION - REMOTE CONTROL
1. Locate the battery cover on the back of
the remote control. Use a screwdriver to
loosen the screw.
2. Install 2 new AAA (AM-4/LR03)
batteries following the diagram inside
the battery box. (The use of new alkaline
batteries is recommended for maximum
performance.)
3. Replace the battery cover and tighten
the screw to secure.
To Next Page
Loading...
Need help?
General