VTech Toot-Toot Drivers Train Set - Getting Started; Battery Removal and Installation; Battery Notice

8
8
8
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
Train
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
back of the train. Use a screwdriver
to loosen the screw.
3. If used or spent batteries are
present, remove these batteries
from the unit by pulling up on one
end of each battery.
4. Install 3 new AAA (AM-4/LR03) batteries following the diagram
inside the battery box. (The use of new alkaline batteries is
recommended for maximum performance).
5. Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
• UsenewalkalinebatteriesorfullychargedNI-MH(NickelMetal-
hydride) rechargeable batteries for best performance.
• Useonlybatteriesofthesameorequivalenttypeas
recommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard
(carbon-zinc) or rechargeable, or new and used batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Removerechargeablebatteriesfromthetoybeforecharging(if
removable).
• Rechargeablebatteriesareonlytobechargedunderadult
supervision.