Instructions
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Locate the battery cover on the bottom of the unit. Use a screwdriver to loosen
the screw and then open the battery cover.
3. If used batteries are present, remove these batteries from the unit by pulling up
on one end of each battery.
4. Install 4 new AA (AM-3/LR6) batteries following the diagram inside the
battery box. (For best performance, alkaline batteries or fully charged Ni-MH
rechargeable batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.
Important: Battery Information
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in re.
Rechargeable Batteries
• Remove rechargeable batteries (if removable) from toy before charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
To Next Page
Loading...