12
Getting started
Add and pair a baby unit
Each newly purchased baby unit (VM301) must be paired to the
parent unit before use. Make sure you power on the baby unit and
the parent unit before pairing.
To pair a baby unit:
On the idle parent unit, press MENU/SELECT.
Press or to choose PAIR/UNPAIR CAM, then press MENU/SELECT
or .
Press MENU/SELECT or again to choose Pair new CAM.
Press or to choose a desired baby unit slot, then press MENU/SELECT.
When the screen displays Please press both [+] and [
-
] keys on CAM
side until POWER indicator ashes Red and Green light,
immediately press and hold + and
-
for 5 seconds on the new baby unit.
The light on the new baby unit ashes red and green alternately.
When pairing is successful, the screen displays the image from the newly
paired baby unit. The light on the new baby unit turns red when it is
powered by AA batteries or turns green when it is powered by AC power.
If pairing fails, the screen displays Pairing failed. Try the pairing
process again.
Any new baby unit paired to an occupied baby unit slot will unpair the
current unit.
Only one baby unit can be paired at a time.
1.
2.
3.
4.
5.
6.
•
•
•
To Next Page
Loading...
Need help?
General
