4
Getting started
Baby unit installation options
The baby unit is ready for tabletop use. Use the provided wall mount if you
want to mount it on a wall. Make sure to test the reception and the baby unit
position before completing the wall mounting installation.
Tabletop to wall mount installation
Option 1: Use this method to x the wall mount securely on the wall.
Place the wall mount on a wall and then use a pencil to mark the top two
holes as shown. Then remove the wall mount and drill two holes in the wall
(7/32” drill bit). Check for reception strength and camera angle before drilling
the holes.
If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than a stud, insert the wall
anchors into the holes and tap gently on the ends with a hammer until the
wall anchors are ush with the wall.
1.
2.
To Next Page
Loading...
Need help?
General
