VTech VM343 User Manual

Quick start guide
VM343
VM305
Go to www.vtechphones.com
to register your product for
enhanced warranty support
and latest VTech product news.
Specifications are subje ct to change without notice.
© 2015 VTech Communications, Inc.
All rights reserved. 04/15. VM343_US_QSG_V1.0
Document order number: 96-010482-010-100
Sound activation
When the infrared LEDs are on, the
image is in black and white. This is
normal due to external light sources.
Depending on the surroundings
and other interfering factors, like
lightings, objects, colors and
backgrounds, the display resolution
may vary. Adjust the baby unit’s
angle, or place the baby unit at a
higher level to prevent glare and
blurry display.
TIP
The baby unit has infrared LEDs that
allow you to see your baby at night or
in a dark room. When the baby unit
detects low light levels, the infrared
LEDs turn on automatically.
NOTE
Mount the baby monitor - Method 2
If you drill the holes into a stud, go to
step 3.
-OR-
Insert the screws into the holes
and tighten the screws until
only 1/4 inch of the screws are
exposed.
Place the baby unit on the wall mount.
Tighten the screw into the threaded
socket at the bottom to secure the baby
unit. Align the holes on the wall mount
with the screws on the wall, and slide the
wall mount down until it locks into place.
Check for reception strength and
camera angle before drilling the
holes.
NOTE
VOL
ON/OFF
3
1
2
SOUND-ACTIVATED SCREEN
On
O
Night vision
Place the wall mount on a wall and
then use a pencil to mark the top
and the bottom holes as shown.
Remove the wall mount and drill
two holes in the wall (7/32” drill bit).
If you drill the holes into an object other
than a stud, insert the wall anchors into
the holes. Tap gently on the ends with a
hammer until the wall anchors are flush
with the wall.

VTech VM343 Specifications

General

Camera	Yes
Night Vision	Yes
Two-way Communication	Yes
Temperature Sensor	Yes
Sound Activation	Yes
Power Source (Parent Unit)	Rechargeable battery
Power Source (Camera)	AC adapter
DECT Technology	Yes
Night Light	Yes
Out-of-Range Indicator	Yes
Low Battery Indicator	Yes
Volume Control	Yes
Belt Clip	Yes
Range	1, 000 ft
Type	Digital
Zoom	Yes, digital zoom
Expandable System	Up to 4 cameras

Summary

Mount the Baby Monitor

Mounting Method 2

Instructions for mounting the baby unit on a wall using screws and anchors.

Sound Activation

Description of the sound-activated screen feature and its indicators.

Night Vision Feature

Explanation of infrared LEDs for night vision and image quality tips.

Product Setup and Installation

What's in the Box

Lists the components included in the package for different models.

Connect and Power On

Steps to connect the device and power it on for the first time.

Mounting Method 1

Instructions for mounting the baby unit on a wall using screws and anchors.

Install and Place Baby Unit

Guidance on installing the battery and placing the baby unit on its mount.