71
of messages and F flash, alternatively,
in the message window, and Rec mem
full appears on the handset screen. You
must delete some messages before
recording new ones.
Your answering system allows you to set
your announcement, to save and delete
messages, activate call screening, to set
number of rings before pick up, and to
access remotely.
Set answering system through voice
guide
This feature is an alternative way for you
to do the basic setup of the answering
system. You can follow the voice guide
to record your own announcement,
set the number of rings, and set the
message alert tone.
1. Press MENU/SELECT on the handset
in idle mode.
2. Press p/q to highlight Answering
sys, then press MENU/SELECT.
3. Press p/q to highlight Voice guide,
then press MENU/SELECT. You hear
a voice prompt, “This voice guide will
assist you with the basic setup of your
answering system.“
4. Set up your answering system by
inputting designated numbers, as
instructed in the voice guide.
NOTES
• You can press on the handset
to quit the voice guide at any time.
• After a power outage, the
telephone base prompts you to
set the date and time, and Smart
call blocker. After these settings are
done or skipped, the telephone
base then prompts if you want to set
up the answering system via voice
guide. Press MENU/SELECT to start
the setup.
Set remote access code
To access your answering system
remotely from any touch-tone phone,
you need to enter a two-digit number
(00-99). By default, the remote access
code is 19.
To change the remote access code:
1. Press MENU/SELECT in idle mode.
2. Press p/q to highlight Answering
sys, then press MENU/SELECT .
3. Press p/q to highlight Ans sys setup,
then press MENU/SELECT .
4. Press p/q to highlight Remote
code, then press MENU/SELECT .
5. Use the dialing keys to enter a two-
digit number.
-OR-
Press p/q to scroll to a desired
two-digit number.
6. Press MENU/SELECT to confirm.
To Next Page
Loading...
