VTech Wiggle & Jiggle Fishing Fun - Getting Started; Battery Removal and Installation; Battery Notice

4
4
4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on
the bottom of the unit and use a
screwdriver to loosen the screw and
open the battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the
battery box.
5. Replace the battery cover and tighten
the screw to secure.
BATTERY NOTICE
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Donotdisposeofbatteriesinre.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.