How to reduce noise and hum from VTL TL6.5 Amplifier?
To reduce noise and hum, connect as many components as possible to a clean AC ground within your system. For the quietest operation, ensure all components are plugged into the same ground potential.
What to do if I am getting noise from video source on VTL Amplifier?
First, disconnect the VCR from the system to see if this solves the problem. If the noise stops, try lifting the ground from the cable TV wire using a cable ground lifting transformer, available at most electronics stores.
What to do if VTL TL6.5 does not turn on?
Check the power cord to ensure it is properly connected to both the preamplifier and the AC outlet. If the power source is not the issue, inspect the fuse unit on the back panel of the preamplifier. If the fuse is blown, replace it and try powering on the preamplifier again. If the problem persists, contact your authorized VTL dealer.
How to fix VTL Amplifier remote control not working?
Loosen the four screws on the back of the remote control unit with a Philips screwdriver, and open the back cover. Remove the old batteries and replace them with new AAA batteries.
What to do if VTL Amplifier has no sound from one channel?
The unit should be taken to a dealer to have the fuses checked and replaced.
Why is my VTL TL6.5 Amplifier volume too loud at low settings?
Either have the manufacturer of the player/DAC adjust the output to a lower level, or take your preamplifier to your dealer and ask them to set the input pad jumper on the CD1 input.
What to do if VTL TL6.5 Amplifier makes ringing noise when touched?
Follow the procedures listed in this manual to remove the tubes and change them for new ones.
What to do if VTL Amplifier has no sound after checking fuses?
They should be checked in this case. In this case the dealer’s service technician should contact the factory.
Why does another remote control affect my VTL TL6.5?
Contact your VTL Dealer or the Factory for a solution to this problem.
To Next Page
General
