Quick Reference: Special Programming Functions
Function Programming Sequence
Enable Trigger Output: To set up to 2 Trigger
outputs to remotely turn on your system
components that can accept the 12V turn-on.
During the power up 90 to 0 countdown
sequence, user holds down any of Input 1 thru 2
buttons, i.e. CD1, CD2 (for trigger 1 through 2).
To set trigger timer, user rotates control knob
clockwise to 99 maximum (to increase trigger time)
or counter-clockwise to 01 minimum (to decrease
trigger time). No two triggers can be set for the
same turn on time - numerical display skips already
selected trigger times.
Disable Trigger Output To undo the Trigger timer, during 90 to 0
power up sequence, hold the button for the
Trigger output and rotate the volume control
counter-clockwise until numerical display shows
OF.
Suppress Power on Countdown timer
If you do not wish to see the 90 to 0 countdown
when the preamp goes through the power up
sequence, you can suppress the display by pressing
the Mute button during the countdown sequence.
Any programmed trigger indication will be
suppressed also.
Set input to Unity Gain (for any input
CD1… Aux)
While the preamp is in operate mode, select the
input you wish to set to Unity Gain. Then hold the
Mon/Proc button and at the same time press the
input button again. The numeric display changes
to UI to indicate that Unity Gain is set., and the
Mute LED blinks.
Remove Unity Gain setting from an input
While the preamp is in operate mode, select the
input that you wish to reset the Unity Gain. Note
the Mute LED blinks. Hold down the Mon/Proc
button first and then press the input again. The
numeric display changes to indicate the volume for
that input prior to setting Unity Gain.
Set Input Level Offset: Input offsets are used
for equalizing volume gain levels between
different inputs that have different output levels,
so that when an input is selected the overall
volume of the system will not change.
While the preamp is in operate mode, hold the
button of the input you wish to set the Offset, and
rotate the volume control knob at the same time.
The numeric display will now indicate the Offset
value that you wish to set. Release the input button
to complete the setting.
To remove Input level Offset, hold the input
button down and turn the volume control
counterclockwise until numeric dis
la
indicates
TL6.5 Preamplifier Owner’s Manual
VTL
23
To Next Page
