7
TRAMPOLINE | ASSEMBLY INSTRUCTIONS
FRAME
Take two curved poles, and join them together. If holding up the poles is difficult, join the sections together on the ground.
Continue until you have connected all the curved poles into twos. Arrange the completed pieces on the ground with the joint
connection facing upwards. These will become the frame ring.
Tip: Apply some general purpose grease or vaseline to the inside of the joints. This will help to protect the parts from creaking
as the frame ages..
1
STEP
Time required: Approximately 1 hour - Number of people required: 2
Quantities:
Parts 8 ft 10 ft 12 ft 14 ft
Safety Padding
1 1 1 1
Jumping Mat
1 1 1 1
Curved Poles
6 8 8 8
Straight Poles
6 8 8 8
W-shaped poles
3 4 4 4
Springs
60 64 72 88
Spring Tool
1 1 1 1
Spring Buttons in W-Shaped and Straight Poles
12 16 16 16
Net
1 1 1 1
*Lower Net Pole
6 8 8 8
*Upper Net Pole
6 8 8 8
*Net Pole Covers
18 24 24 24
*Net Pole Foams
18 24 24 24
*Elastic Ties
18 24 24 24
*Nuts
18 24 24 24
Spring Buttons
12 16 16 16
*Parts pre-assembled
To Next Page
Loading...
