VuQube VQ2000 - Page 19

Page 17
IMPORTANT! YOU MUST RUN THE CHECK SWITCH AFTER SWITCHING TRIOS!
IMPORTANT! YOU MUST RUN THE CHECK SWITCH AFTER SWITCHING TRIOS!
61, 110, 119 TRIO (DISH 1000a)
1. On the VuQube controller, press and release the ON button.
Wait for the status light to flash orange, and then flash
green or red.
2. Press and release the ON button 4 times.
The status light starts rapidly flashing green and red.
3. Press and hold the button for 4 seconds.
The status light will turn orange for 1 second, and then start flashing
green or red.
4. Press OFF. GO TO PAGE 12 AND RUN THE CHECK SWITCH.
110, 119, 129 TRIO (DISH 1000)
1. On the VuQube controller, press and release the ON button.
Wait for the status light to flash orange, and then flash
green or red.
2. Press and release the ON button 4 times.
The status light starts rapidly flashing green and red.
3. Press and hold the button for 4 seconds.
The status light will turn orange for 1 second, and then start flashing
green or red.
4. Press OFF. GO TO PAGE 12 AND RUN THE CHECK SWITCH.