vorTex MIxer InTroduCTIon
Your Vortex Mixer is ready for most one-handed applications. The Vortex Mixer
operates by mixing tubes just prior to testing.
OPERATING TIPS
These units are not intended for continuous use over extended periods of time. A
built-in temperature sensor will prevent the unit from overheating by shutting the
motor down. If this occurs, allow the motor to cool down and the unit will be able
to resume normal operation. Decrease the duration of the time unit is used between
rest periods.
NOTE: The cup head is permanently attached to the unit. DO NOT try to remove
or permanent damage will occur.
analog vorTex MIxer oPeraTIng InsTruCTIons
1. Make sure the 3-way rocker switch is in the center, off position. Plug the power
cord into a properly grounded outlet.
2. For continuous operation, push the rocker switch to the right, on position. For
intermittent/touch operation, push the rocker switch to the left, auto position.
3. In either case, turn the speed knob to 1. In the on position, you will see the
head in motion immediately. In the auto position, the vessel you are using must
be pushed down on the head attachment to achieve motion. To get the desired
mix, vary the speed, using the speed knob, and/or vary the angle of contact
and pressure against the head.
4. When finished with either continuous or intermittent operation, return rocker
switch to the center, off position.
5. The intermittent, auto mode is intended for short mixing times of one (1)
minute or less at full speed. A rest period of two (2) minutes is recommended
to minimize the possibility of overheating the motor. The unit can become
warm to the touch with constant use. There is nothing wrong with it. At high
performance settings the motor (UL recognized component) simply puts out
more heat.
6. To completely cut off power to the unit, disconnect the power cord from the
wall outlet.
Manufactured by:
201 Wolf Drive • Thorofare, NJ 08086-0087
Phone: 856-686-1600 • Fax: 856-686-1601 • E-mail: troemner@troemner.com
www.troemner.com
715115-00 (REV 2- 8/15)
TROEMNER LLC
To Previous Page
Loading...
