W'eau WMIP-003 - Switching Heating;Cooling Modes; Setting Water Temperature; Real Data Checking

- 9 -
5.3 Switch Heating & Cooling mode
Under main interface, press to switch Heating & Cooling mode.
5.4 Set the desired water temperature
When machine is under main interface in Heating or Cooling mode, press or directly to adjust
the desired water temperature, the data will be saved in 3 seconds or you can press to save the data.
5.5 Real data checking
Hold for 3 seconds to enter the real running data checking.
Press or to check below parameters , press to check the data of selected parameter,
press again to return back. Press to return back the main interface.
Parameter
Name
Range
A01
Inlet water temp.
-30~99
℃
A03
Ambient temp.
-30~99
℃
A04
Exhaust temp.
0~125
℃
A06
Piping system temp.
-30~99
℃
A10
Compressor current
A11
Radiator temp.
A12
DC bus voltage
A13
Compressor speed
A14
PCB current
A15
DC fan motor speed
0~1590
NOTE: The other parameters which is not shown on below sheet is for reservation, no real function.
5.6 Parameters checking
Hold for 3 seconds to enter the real running data checking.