What to do if my W'eau Heat Pump LED wire controller has no display and the heat pump isn't running?
If there is no display on the LED wire controller and the W'eau Heat Pump is not running, the cause may be no power supply. Check the cable and circuit breaker to ensure they are properly connected.
What does error code E03 mean on my W'eau WMIP-003 Heat Pump?
Error code E03 on your W'eau Heat Pump indicates insufficient or no water flow, or a loose wiring situation for the water flow switch. Check the water pump and piping system. Also, check the wiring or replace the water flow switch.
What does error code E09 mean on my W'eau Heat Pump?
Error code E09 on your W'eau Heat Pump suggests a bad connection or a broken controller/PCB. First, check the wiring between the PCB and the controller. If the problem persists, replace the controller or PCB.
What does error code E10 mean on my W'eau WMIP-003 Heat Pump?
Error code E10 on your W'eau Heat Pump indicates a bad connection or a broken controller/PCB. Check the wiring between the driver board and the controller. If the issue continues, replace the controller or driver board.
What to do if my W'eau WMIP-003 Heat Pump LED wire controller displays the actual water temperature?
If the LED wire controller displays the actual water temperature, it could mean that the water temperature is reaching the setting value, indicating the heat pump is under constant temperature status. Alternatively, the heat pump might have just started running. Verify the water temperature setting. If the heat pump has just started, allow it to run for a few minutes.
What does error code E46 mean on my W'eau WMIP-003?
Error code E46 on your W'eau Heat Pump indicates a bad connection or a broken fan motor. Check the wiring of the fan motor. If necessary, replace the fan motor.
What does error code E15 mean on my W'eau Heat Pump?
Error code E15 on your W'eau Heat Pump indicates a temperature sensor open circuit or short circuit. Check the sensor wiring. If the problem persists, replace the temperature sensor.
What does error code E16 mean on my W'eau WMIP-003?
Error code E16 on your W'eau Heat Pump suggests a temperature sensor open circuit or short circuit. First, check the sensor wiring. If the problem persists, replace the temperature sensor.
What does error code E18 mean on my W'eau WMIP-003?
Error code E18 on your W'eau Heat Pump indicates a temperature sensor open circuit or short circuit. Check the sensor wiring. If the problem continues, replace the temperature sensor.
Why does my W'eau WMIP-003 Heat Pump show error code E04?
Error code E04 on your W'eau Heat Pump is a protection for the system due to low ambient temperature.
Provides detailed technical specifications for different pool heat pump models.
Details optimal placement criteria for the heat pump unit.
Explains the initial steps before starting the heat pump operation.
Guides users on how to properly connect the heat pump electrically.
Explains the phenomenon of condensation and how to drain it.
Illustrates the internal wiring connections for the pool heat pump.
Describes the visual elements and indicators on the LED controller.
Provides instructions for powering the heat pump on and off.
Explains how to change between heating and cooling operational modes.
Guides users on setting the target water temperature.
Details how to view operational parameters and sensor readings.
Lists and explains various adjustable parameters and their ranges.
Instructions on how to manually initiate the defrosting cycle.
Steps to restore the heat pump to its original factory default settings.
Lists error codes, their reasons, and corresponding solutions.
Addresses malfunctions not indicated by specific error codes on the controller.
To Next Page
General
