What does error code E21 mean on my W'eau WMIP-003 Heat Pump?
Error code E21 on your W'eau Heat Pump indicates a temperature sensor open circuit or short circuit. Check the sensor wiring. If the problem persists, replace the temperature sensor.
What to do if my W'eau Heat Pump LED wire controller is short running?
If your W'eau Heat Pump LED wire controller is short running, it could be due to several reasons: 1. The fan is not running. 2. Insufficient air ventilation. 3. Insufficient refrigerant. Check the cable connections between the motor and fan, and replace if necessary. Ensure the heat pump unit has good air ventilation by removing any obstacles. If the issue persists, replace or repair the heat pump unit.
What does error code E12 mean on my W'eau WMIP-003?
Error code E12 on your W'eau Heat Pump indicates insufficient gas in the system. Check for gas leakage in the piping system.
What to do if my W'eau WMIP-003 LED wire controller has water stains?
If your W'eau Heat Pump LED wire controller has water stains, it could be due to concreting or water leakage. For water leakage, carefully check the titanium heat exchanger for any defects.
Provides detailed technical specifications for different pool heat pump models.
Details optimal placement criteria for the heat pump unit.
Explains the initial steps before starting the heat pump operation.
Guides users on how to properly connect the heat pump electrically.
Explains the phenomenon of condensation and how to drain it.
Illustrates the internal wiring connections for the pool heat pump.
Describes the visual elements and indicators on the LED controller.
Provides instructions for powering the heat pump on and off.
Explains how to change between heating and cooling operational modes.
Guides users on setting the target water temperature.
Details how to view operational parameters and sensor readings.
Lists and explains various adjustable parameters and their ranges.
Instructions on how to manually initiate the defrosting cycle.
Steps to restore the heat pump to its original factory default settings.
Lists error codes, their reasons, and corresponding solutions.
Addresses malfunctions not indicated by specific error codes on the controller.
To Next Page
General
