WABECO D2000E - Technical Data; Universal Lathe D2000 E

6
1 . Technical Data
1.1 Universal Lathe D2000 E
Working range
Centre distance.......................................................... 350 mm
Centre height.............................................................. 110 mm
Work spindle
Power ......................................................................... 1,4 kW, 230 V, 50 Hz
Spindle speed infinetely variable................................ 30 – 2300 r.p.m.
Spindle bore ...............................................................
20 mm optional 30 mm
Taper in spindle nose................................................. MT3 – only for spindle bore 20 mm
Cross table
diameter of chuck work above cross slide rest..........
126 mm
Travel of cross slide ................................................... 110 mm
Travel of longitudinal slide 58 mm
Swivel range of the upper slide rest........................... 360°
Height of turning tools max. ....................................... 20 mm
Guideways
Longitudinal support................................................... ground guiding bars
Cross support................................................................ adjustable dovetail guide
Stripping rings ............................................................... protection of the guides
Length of guides............................................................ 575 mm
Width of guides.............................................................. 130 mm
diameter of chuck work, measured above the guiding
bars ...............................................................................
220 mm
Tail stock
Tail spindle´s range of displacement ............................ 65 mm
Tail spindle´s hole bore................................................. cone2
lateral displacement of the tailstock to both sides ........
±10 mm
Advance
Automatic advance........................................................
0,085mm/r.p.m. optional 0,16
Screw cutting attachment - optional
- metric thread ........................................................... 0,4 - 4,0 mm
- inch thread .............................................................. 10 - 32 thread per inch (TPI)
Noise values according DIN 45635 - part 1
Emission data:
no-load running LpA = 63 dB(A)
load running
LpA = 67 dB(A)
- Subject to technical alterations -