WABECO D2000E - Universal Lathe D3000 E

8
1 . Technical Data
1.3 Universal Lathe D3000 E
Working range
Centre distance ............................................................. 500 mm
Centre height................................................................. 110 mm
Work spindle
Main drive...................................................................... electronic adjustable motor
Power ............................................................................ 1,4 Kw, 230V, 50 Hz
Spindle speed infinetely variable................................... 30 - 2300 r.p.m.
Spindle bore ..................................................................
20 mm Optional 30 mm
Taper in spindle nose................................................. MT3 – only for spindle bore 20 mm
Advance
Automatic advance........................................................ 0 - 250
Cross table
diameter of chuck work above cross slide rest.............
126 mm
cross table range of displacement ................................ 100 mm
turning carriage´s range of displacement...................... 58 mm
swivel-feature of the upper slide rest ............................ 360°
Height of turning tools max. .......................................... 20 mm
Guideways
Longitudinal support...................................................... ground guiding bars
Cross support................................................................ adjustable dovetail guide
Stripping rings ............................................................... protection of the guides
Length of guides............................................................ 740 mm
Width of guides.............................................................. 130 mm
Ø of guides.................................................................... 30 mm
diameter of chuck work, measured above the guiding
bars ...............................................................................
220 mm
Tailstock
Tail spindle´s range of displacement ............................ 65 mm
Tail spindle´s hole bore................................................. cone2
lateral displacement of the tailstock to both sides ........
±10 mm
Advance
Automatic advance........................................................ 0-250 mm/min
Screw cutting attachment
metric thread ..........................................................................
0,4 - 3,0 mm
inch thread..............................................................................
10 - 32 thread per inch
Noise values according DIN 45635 - part 1
Emission data:
no-load running LpA = 63 dB(A)
load running
LpA = 67 dB(A)
- Subject to technical alterations -