44
CAS-GPS IVU BASIC SYSTEMS INSTALLATION MANUAL DOCU0085 Revision Q
General Wiring Principles
• Blanking plugs or caps are supplied and must be in place for all unused connectors i.e. 24 way Deutsch
Connector on the IVU for example
• All cable joins/splices should be soldered and heat shrink insulation applied
• All wires are to be labelled i.e. IGN, VIN+ ,GND , REV using the supplied labels
• DO NOT use clamp type splice devices to tee into vehicle wiring
• Crimp type ring terminals should be used for all terminal blocks
• All wiring should be run in the supplied flexible conduit along with the boot ends also supplied in the kit
• Ethernet connections made to an IVU must be of a shielded construction
To Next Page
Loading...