Operation BS 60-4s
22 wc_tx001488gb.fm
4 Operation
4.1 Preparing the Machine for First Use
Preparing for first use
To prepare your machine for first use:
4.1.1 Make sure all loose packaging materials have been removed from the
machine.
4.1.2 Check the machine and its components for damage. If there is visible
damage, do not operate the machine! Contact your Wacker Neuson
dealer immediately for assistance.
4.1.3 Take inventory of all items included with the machine and verify that
all loose components and fasteners are accounted for.
4.1.4 Attach component parts not already attached.
4.1.5 Add fluids as needed and applicable, including fuel, engine oil, and
battery acid.
4.1.6 Move the machine to its operating location.
4.2 Recommended Fuel
This engine is certified to operate on automotive unleaded gasoline.
Use only fresh, clean gasoline. Gasoline containing water or dirt will
damage fuel system.
Use of oxygenated fuels
Some conventional gasolines are blended with alcohol. These
gasolines are collectively referred to as oxygenated fuels. If you use
an oxygenated fuel, be sure it is unleaded and meets the minimum
octane rating requirement.
Before using an oxygenated fuel, confirm the fuel's contents. Some
states / Provinces require this information to be posted on the fuel
pump.
The following are Wacker Neuson approved percentages of
oxygenates:
ETHANOL - (ethyl or grain alcohol) 10% by volume. You may use
gasoline containing up to 10% ethanol by volume (commonly referred
to as E10). Gasoline containing more than 10% ethanol (such as E15,
E20, or E85) may not be used because it could damage the engine.
If you notice any undesirable operating symptoms, try another service
station, or switch to another brand of gasoline.
Fuel system damage or performance problems resulting from the use
of an oxygenated fuel containing more than the percentages of
oxygenates mentioned above are not covered under warranty.
To Next Page
Loading...
