6-8 BA D24 en/us* 1.0 * D24_1_0_600.fm
6 Transportation
1. Empty the skip and lower it to middle position.
2. Remove all dirt from the vehicle.
3. Park the vehicle on firm, level, and horizontal ground.
4. Activate road mode.
5. Stop the engine.
6. Remove the starting key and carry it with you.
7. Machine with optional cabin:
- Safely store all loose objects.
- Close and lock all covers and the door.
8. The rollbar can be lowered to reduce the transport height –
see chapter “ Rollbar” on page 4-16
9. Put the center-pivot prop in place – see "Center-pivot prop" on
page 6-6.
10.Use suitable lifting gear (chain, etc.).
11.Put the lifting gear through bracket A on the edge of the skip and
fasten it on lifting eyes B on the left and right on the chassis with
suitable slings.
12.Slowly raise the vehicle until there is no more contact with the ground.
13.Wait until the machine does not swing any more.
14.Slowly raise the vehicle to the required height and load.
15.If the machine balance, and the condition and position of the slings is
correct, slowly raise the machine to the required height and load it.
The manufacturer’s warranty shall not apply to accidents or damage
caused by loading or transporting.
To Next Page
Loading...
Need help?
General
