Wacker Neuson E13-01

5-8 BA EZ17 en* 1.1 * ez17b500.fm
5 Operation
5.6 Lights/signalling system
WARNING
Accident hazard due to blinded motorists!
Working lights can blind motorists. This can cause serious injury or death.
► Stop machine operation if motorists are blinded.
► Take up operation again only when sufficient illumination of the
working area is ensured without blinding motorists.
Working lights
Information
With the roof-mounted spotlight option, all work lights are switched on
and off together.
The switch is located on the control lever base.
Information
Switch on the working lights in conditions of poor visibility. If illumination
still is not sufficient, use external lights. If this is yet not enough to
illuminate the job site sufficiently, stop machine operation and only start it
again when sufficient illumination can be ensured.
Fig. 82
A B
Position Designation
A Boom light
B Front and rear roof lights (option)
Fig. 83
38
Position Function
ON Press switch 38 down
Working lights switched on, the
indicator light in switch 38 illu-
minates
OFF Press switch 38 up
Working lights switched off, the
indicator light in switch 38 goes
out