BA E16 en* 1.0 * E16_10_510.fm 5-41
Operation 5
Preparation for hydraulic quickhitch (option)
The HSWS preparation is a hydraulic auxiliary control circuit attached to
the vehicle boom that was designed, developed and released for the
hydraulic quick coupler systems described in this operator's manual.
Wacker Neuson is not liable for injuries or damage if at least one of the
following items is not complied with:
• Follow the operator's manual for the hydraulic quickhitch.
• Store the Operator’s Manual of the hydraulic quickhitch together with
the Operator’s Manual of the vehicle.
• For non-released quickhitch systems, there may be differences in the
operating functions or the operation of the vehicle. Observe the
operator's manual of the quickhitch system or the attachment.
Nevertheless, should a non-released HSWS be used, the following points
must also be observed:
• If required, modifications on the vehicle (for example additional
adhesive labels) or the Operator’s Manual of the vehicle (if operation is
different) must be made.
• The intended purpose of the vehicle may be restricted.
• Assembling a hydraulic quick coupler system that does not fit with the
vehicle or its interface (e.g. pressure settings) may void the declaration
of conformity of the vehicle. Contact a Wacker Neuson service center.
• Assembling a hydraulic quick coupler system to a vehicle that does not
fit with the vehicle or its interface (e.g. pressure settings) may void the
declaration of conformity of the hydraulic quick coupler. Contact a
Wacker Neuson service center.
To Next Page
Loading...
Need help?
General
